1. Regular cleaning: Carry out regular and regular cleaning of stone sculpture. When cleaning, first apply a neutral detergent to the surface of the stone sculpture, and then wipe the surface of the stone sculpture with a lint-free towel. For larger stains, use Spray it with a manual spray gun, then wipe it off with a dry towel, remember to be gentle;
2. Dry environment: Some stone sculpture need to be placed in an unventilated environment, but
stone mountain carving are placed in a dry environment to protect them;
3. Sweat prevention: Sometimes some sweat on the human body can also cause stone sculpture to rust. Therefore, it is recommended to wear gloves when holding them. One is to prevent the stone sculpture from scratching the back of the hand, and the other is to prevent sweat from causing stone sculpture to rust ;
4. Gap cleaning: When cleaning the crevices of stone mountain carving, it is best to wipe them with a cotton ball after wetting them, and wipe them from beginning to end along the crevices to prevent omissions. Remember not to wipe them directly with a wet towel;
5. Heavy dirt cleaning: If the dirt on the stainless steel
stone carving is too heavy, blow it with a cold wind hair dryer first, then clean it with a straw brush, and finally use a soft brush to finish it. Never use metal polish or any other solvents;
Sixth, scratch repair: For the scratches on the stone sculpture, as long as they are not very serious, they can be polished and repaired. In addition, we should avoid scratches on the stone sculpture in daily life, because if the scratches are serious, it is not very good dealt with;
7. Waxing protection: After cleaning the stone mountain carving, apply a thin layer of microcrystalline wax (colorless wax) to it, basically once a year.
