When repairing Stone Garden Decor, first remove the damaged parts. If it is a steel plate part, first reshape it, remove rust, clean and dry it.
1. First, cut the
stone carving cloth according to the rough shape of the workpiece. Under amateur conditions, baking method can be used to remove wax. Find a 500-1000W electric stove. After the power is red and hot, put the stone carving cloth on it and bake it until it smokes.
2. After preparing the stone carving cloth, you can make glue. There are many formulas for glue. Under amateur conditions, epoxy resin and polyamine resin are generally used in a ratio of 1:1. The characteristics of this formula for Stone Garden Decor are that the ratio requirements are not strict, the curing time is long, and the longer curing time can obtain a leisurely operating time. Production method: first pour the two resins into a wide-mouthed container in a ratio of 1:1 , stir thoroughly with a stick and mix well.
If it feels too thick when mixing, add some tinna water or acetone to dilute it. The consistency is generally good so that it doesn`t string when you lift the stick.
3. After mixing the glue, you can start the papering work. First use a brush to apply a layer of glue to the inner and outer surface of the workpiece, then press the cut stone carving cloth onto the glue surface, use a brush to lightly press it to make it adhere tightly and allow the glue to penetrate into the stone carving cloth; after the first layer of stone carving cloth has penetrated Apply a second layer of glue and stick a second layer of stone carving cloth.
Factors such as the installation space should be taken into consideration when laminating, otherwise it will be troublesome if it is too thick and cannot be installed. After pasting, you can find a safe place to let it solidify naturally. However, if it takes a long time and conditions permit, you can bake it in an industrial oven or paint room at 120 degrees for 2-4 hours.
