Marble Sculpting are generally carved through different models, and various carving tools are used in the carving process. For stone carving figures, it is very important to carve out the charm of the figures. Whether the work is up to standard or good The degree of badness has a lot to do with the charm of the sculpture, and the charm of the stone figures is very difficult to carve. The following Marble Sculpting will introduce you how to solve the problem of the charm of the stone figures in the carving process.
1. Find a horizontal plane at the original bottom, and then place it on the flat plates with coordinate lines drawn, so that it can effectively follow the intersection lines of the flat plates drawn on some of the original bottom edges, and then repeat To restore, find a cross coordinate line in the original bottom plate, and the space of the coordinate line should pass through the higher point of the original circle vertically.
2. Next, find two steel squares and place them in parallel. There will be a distance of three meters between the two classrooms, and then place them vertically on the flat plate. In the same coordinate line, let the pencil rely on With the sliding of these steel squares, the original model will have very accurate spatial vertical characteristics, and then draw two vertical lines left and right, and finally connect these four lines together, so that the plane coordinates and space coordinates are Formed, in the process of carving stone figures, no matter how to carve, all these lines must be drawn.
3. In the process of engraving stone figures, it is necessary to choose free space coordinate lines or coordinate points on the prototype. However, the wider front has various coordinates, and the wider side has different coordinates. There are side coordinates, but the way of finding the coordinate system and coordinate points is basically the same as the way of finding in the previous step. They must be staggered, and these lines should be used as the central vertical coordinate lines, and the marking should be clear.
4. Find out the coordinates of the bottom surface on the material of the originally selected stone carving figure, and then cut out all the coordinates of these planes in time, and use the entire bottom surface or plane as their standard. The space coordinate line created above is very good. Based on this, we should cut off the wilderness, re-mark the disconnected coordinate vertical line clearly and continuously remove the redundant part, and find a lot of coordinate points. , it is also very important in this way.
5. In order to save effort, you can lay all the original relatively tall works on the ground for processing, so that some original accurate coordinates can be marked.
