The design of Landscape Stone should pay attention to the principle of material technology. Landscape Stone can be easily formed into beautiful streamlined products to highlight the contemporary flavor of the content. Curved streamlines should be used in the design. Because Landscape Stone are light and strong, they can be used to create cool, strong supporting works with small areas. Sometimes the surface needs to be sprayed afterwards. Latex coats have adhesion and have a certain flattening effect under the action of tension when dried, so they are not suitable for showing delicate textures. This needs to be considered carefully when planning. The original mold can be made of clay sculpture. After the stone carving is completed, it is allowed to dry naturally and the Landscape Stone mold design can be carried out.
The hand-laying method is used for production. According to the morphological characteristics of the stone carving and from the perspective of being conducive to forming and mold release, the grinding tool is broken down into multiple modules for reproduction. Shape them and combine them into a whole. The overall solution is spray painting, and a Landscape Stone work is completed.
Landscape Stone mold production is the key to shaping. Plaster is often used for mold production, but gypsum has low strength and is easily deformed over time. Molds can be processed using silicone and Landscape Stone raw materials. Silica gel is in a fluid state when used, with strong fluidity and filling properties. The elastomer material produced through the condensation reaction has relatively large compression deformation, and the water in the original mold will not have any harm to the condensation reaction. After chemical cross-linking, the silica gel has a compact structure and does not adhere to the original Landscape Stone. Used as the surface of Landscape Stone grinding tools, it can reproduce the shape of the work with high quality and can also successfully remove the mold. However, the chemical cross-linked body is easy to deform and requires a supporting medium. The easy-to-form characteristics of Landscape Stone are used as the mold medium.
Landscape Stone mold production method: configure the silicone and apply it on the original mold in batches with a silicone layer of 1mm. After the silica gel is chemically cross-linked, 3mm upper and lower Landscape Stone layers are formed on the silica gel. After drying, cut the modules separated by the edge with the mold. Pay attention to cut the silica gel layer of the Landscape Stone layer and cut it. Connecting ribs are made between the module blocks, and positioning grooves are set at the connecting ribs to ensure that the connecting ribs make the module blocks form a whole. After the work is completed, the unit blocks of the Landscape Stone are removed from the mold, and then the silicone layer is removed. The removed silicone is immediately placed into the Landscape Stone module mold.
1. Landscape Stone artwork is not suitable for long-term exposure to the hot sun and may cause cracking. Therefore, when placing them, be careful not to place them in the dialog box.
2. Landscape Stone artwork is not suitable for placement in extremely humid rooms. Very humid environments can also cause Landscape Stone to grow hairy.
3. Landscape Stone artwork is not suitable to be placed in hot environments such as fires, earthen kangs, and stoves. Like living in the north, the heating is on in winter and the air conditioning is on in summer. Therefore, it is necessary to consider that the Landscape Stone artwork cannot be blown directly towards the air outlet, and do not place it near the heating pipe.
